kz1300 banner

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC:

Out in the cold 3 months 3 weeks ago #30144

  • PaulD
  • PaulD's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 48
  • Thank you received: 7
Out on the beast today, bit of a false start as she only fired up on four cylinders After much cursing and swearing and as I couldn’t think of anything else I tapped the float bowl on the offending carb and all was good. Did 60 miles and apart from being a bit “fluffy” when pulling away and the idle being a bit lumpy she ran really strong. I’m hoping balancing the carbs again will cure that. Really enjoyed the run out despite the bloody cold.

Attachment not found

Attachment not found

Attachments:
The following user(s) said Thank You: zed_thirteen

Please Log in or Create an account to join the conversation.

Last edit: by PaulD.

Out in the cold 3 months 3 weeks ago #30145

  • mizztheman
  • mizztheman's Avatar
  • Offline
  • Elite Member
  • Elite Member
  • Posts: 188
  • Thank you received: 81
Hi Paul,
Good to see you’ve got her out on the road. Too cold for me. 
The following user(s) said Thank You: Bucko, PaulD

Please Log in or Create an account to join the conversation.

Out in the cold 3 months 3 weeks ago #30146

  • PaulD
  • PaulD's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 48
  • Thank you received: 7

Hi Paul,
Good to see you’ve got her out on the road. Too cold for me. 

cheers Martin, I’ve just finished rebuilding my spare set of carbs so I’ll get your cleaning tool back to you asap. Just a few niggles to sort and some cosmetics that are sending my ocd into overdrive then I’ll be happy. 
 

Please Log in or Create an account to join the conversation.

Out in the cold 3 months 2 weeks ago #30147

  • dcarver220b
  • dcarver220b's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 374
  • Thank you received: 90
Good looking ride!
 
The following user(s) said Thank You: PaulD

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
Time to create page: 0.062 seconds
Powered by Kunena Forum