Welcome, Guest
Username: Password: Remember me

TOPIC:

Hydraulic Clutch Converstion 2 years 10 months ago #29234

  • scotch
  • scotch's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 1887
  • Thank you received: 830
www.kz1300.com/index.php/forum/suspensio...draulic-clutch#24364

I have since removed the small shim-plate as I determined it wasn't required, after-all.
1980 KZ 1300 sr# KZT30A-009997
Always High - Know Fear !

Please Log in or Create an account to join the conversation.

Last edit: by scotch.

Hydraulic Clutch Converstion 2 years 9 months ago #29279

  • SteveSmith
  • SteveSmith's Avatar
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 26
  • Thank you received: 1
Hi, I have all the parts and am just getting all my duck lined up ready to start cutting.

I understand I'll need to fill out the inside of the slaves piston with a shaped piece of metal, no problem there and I'm thinking I'll 'gorilla glue' that in place.

The bit I'm uncertain with is that the adjuster screw actually screws into a piece behind the casing, and it's travel is restricted to about 3/8" maybe? 
Do I just leave all that gubbins in place, remove the nut, washer and 'L' shaped lever?

Cover me guys, I'm going in :-)
1979 KZ1300-A1

Please Log in or Create an account to join the conversation.

Time to create page: 0.094 seconds
Powered by Kunena Forum