kz1300 banner

Welcome, Guest
Username: Password: Remember me
Electrical
  • Page:
  • 1
  • 2

TOPIC:

Dynatek DDK2-18C 1 month 2 weeks ago #30314

  • f_schenk
  • f_schenk's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 2
  • Thank you received: 0
Anyone happen to have a Dynatek DDK2-18C Ignition Kit that's sitting on a shelf not being used? If so I am a buyer for it.

Please Log in or Create an account to join the conversation.

Dynatek DDK2-18C 1 month 1 week ago #30324

  • dcarver220b
  • dcarver220b's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 374
  • Thank you received: 90
Sorry, not me!

Please Log in or Create an account to join the conversation.

Dynatek DDK2-18C 1 month 1 week ago #30328

  • zed_thirteen
  • zed_thirteen's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 505
  • Thank you received: 131
I bought a faulty one of eBay hoping to fix the problem output but removing the resin pulled component from the board and made it useless.

I know Dyna have to protect their design but I bought my Dyna ignition to extend the life of my Z13 and Dyna quickly stopped producing it and removed support. If it goes wrong now it's just tough :-(
1980 KZ1300 B2 Touring/A2
1990 ZZ-R1100 C1

Please Log in or Create an account to join the conversation.

Dynatek DDK2-18C 1 month 1 week ago #30330

  • Kawboy
  • Kawboy's Avatar
  • Offline
  • Sustaining Member
  • Sustaining Member
  • Posts: 2575
  • Thank you received: 808
Don't be throwing in the towel yet. I haven't seen a circuit board that couldn't be repaired. It's specialty work yes, but somebody should be able to help you out.

Please Log in or Create an account to join the conversation.

Dynatek DDK2-18C 1 month 1 week ago #30333

  • f_schenk
  • f_schenk's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 2
  • Thank you received: 0
Any known systems that will fit / work?

Please Log in or Create an account to join the conversation.

Dynatek DDK2-18C 1 month 1 week ago #30335

  • zed_thirteen
  • zed_thirteen's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 505
  • Thank you received: 131
I just can't find anything to shift the resin. I had been using a dremel to grind some away. You can see where two of the output transistors are lifted the resin pulled one of the resistors and some SMD capacitors..  There's a lot of green on the underside of the resin which could mostly be lacquer.

I need something that will dissolve the resin. Acetone isn't touching it
1980 KZ1300 B2 Touring/A2
1990 ZZ-R1100 C1
Attachments:

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
  • 2
Time to create page: 0.130 seconds
Powered by Kunena Forum